Output values: 2 x 0-30 V, 0-2 A, total power 2×60 W
The two outputs are independent and isolated
The outputs can be wired in either series or parallel to provide voltages up to 60 volts or currents up to 4 amps
Linear regulation
Constant voltage or constant current operation
Voltage Setting: By coarse and fine controls
Current Setting: By single logarithmic control
Independent digital voltage and current meters for each output with 4 digit resolution
Voltage meter:
• Resolution: 10 mV
• Accuracy: 0.3 % of reading ± 3 digits
Current Meter:
• Resolution: 1 mA
• Accuracy: 0.5 % of reading ± 3 digits
Ripple & noise: Typically < 1 mV rms (CV mode, 20 mHz bandwidth)
Switchable local or remote sensing
Silent fan-free cooling
DC output on/off switch
All outputs are intrinsically short circuit proof, and are protected against external voltages and reverse currents
Output terminals: Universal 4mm safety binding posts on 19mm (0.75”) spacing. Terminals can accept fixed shroud 4 mm plugs, standard 4 mm plugs, fork terminals and bare wires
Dimensions: 1 ¼ module, 312,5(W) x 200(H) mm
Option: TTICAL Calibration certificate with results
Teklab Oy
Address: Länsikaari 6A, 07900 Loviisa
Tel: +358-19-536 000
E-mail: info@teklab.fi